Did you know the Cybertruck’s air suspension automatically levels the truck, even while it’s asleep? This is a great feature, especially for camping or off-road adventures. However, it can be an issue when lifting a wheel to change a tire.
Fortunately, there’s a solution: Jack Mode.
Jack Mode
Jack Mode is made for jacking up the truck and prevents the Cybertruck from self-leveling.
To enable Jack Mode, you’ll first need to set the Ride Height to Medium from Controls > Dynamics > Ride Height. You can also set it from the Tesla app by navigating to the Controls section and sliding up until you see Ride Height. This will give you enough clearance for most jacks to get under the truck and lift it.
You can also activate Jack Mode in Low or High, but Tesla recommends a Medium ride height for best control of the vehicle and sufficient tire clearance to safely remove and reinstall the tire. However, once the vehicle is in Jack Mode, the Ride Height cannot be changed.
Next up, go to Controls > Service > Jack Mode to enable Jack Mode. The vehicle will warn you that Jack Mode is enabled and can either be disabled by pressing the button again or by putting the vehicle into drive.
For the duration that Jack Mode is active, it is safe to lift your Cybertruck, even on one side only. It will not self-level for the duration that Jack Mode is enabled.
Automatic Jack Mode
Jack Mode can also activate automatically to protect the suspension from potential damage. For example, if the vehicle’s bumper is resting on a curb, Jack Mode may engage on its own.
Once the obstacle is cleared, or if you shift into Drive or Reverse, Jack Mode will automatically be disabled.
